Step 4
Mount the camera to the bracket.
qAttach the housing base to the mount bracket using the hexagon screws (M5, 4 pcs.) attached to the housing base*.
(Recommended tightening torque: 2.45 N·m {1.81 lbf·ft})
The “REAR” mark of the housing base shall be direct- ed to the wire hook section.
*Special screw: These screws are hexagon screws. Use an M5 hexagon wrench.
Hexagon screws (M5, 4 pcs.) attached to the housing base
Wire hook section
Housing base
w Make sure that the projection of the plate spring on the upper side of the camera is located on the “START” position. If not, turn the plate clockwise to locate the projection at the “START” position.
Plate spring | Projection |
Plate
eConnect the safety wire (accessory) to the mount bracket. Refer to the operating instructions of the mount bracket for further information about where to con- nect the safety wire.
When using the optional mounting bracket
<Installation example>
Safety wire
rAttach the camera to the housing base. When attach- ing the camera to the housing base, the positioning pin on the upper side of the camera shall be on the “REAR” side. Make sure that the camera is securely attached to the mount bracket by turning the camera to the direction of the arrow as illustrated. Then, secure the camera to the mount bracket with the screws* removed when detaching the housing base.
(Recommended tightening torque: 2.45 N·m
{1.81 lbf·ft})
*Special screw (Fixing screw): These screws are hexa- gon screws. Use an M5 hexagon wrench.
Overhead view
Positioning pin
When the camera is | When the camera is secured |
attached | to the mount bracket |
23
