How to detach the housing base

Before attaching the camera to a custom-made mount bracket, detach the housing base and attachment pipe from the camera so that installation and connections can be performed.

Step 1

Remove the fixing screws (3 pcs.*) that are securing the housing base and the camera.

The removed screws will be required when attaching the camera to the housing base. Use caution not to lose these screws.

*Special screw (Fixing screw): These screws are hexagon screws. Use an M5 hexagon wrench.

Fixing screws (3 pcs.)

Housing base

Camera

Protection Cover

Note:

If the front and rear sunshields (accessory) are attached to the camera, detach them by performing steps 5 - 7 of “Installation” in the reverse order. (Pages 24 and 25)

Protection Cover

IMPORTANT:

Remove the Protection Cover from the camera after the installation is complete.

Step 2

To separate the housing base from the camera, turn the housing base to the direction of the arrow as illustrated. (Refer to the illustration in Step 1)

Step 3

Remove the attachment pipe from the upper base by loosening 4 screws.

21

Page 21
Image 21
Panasonic WV-SW598 installation instructions How to detach the housing base