6.0 Disarming
When your system is disarmed, it deactivates any alarms in progress, and it deactivates the zones so the alarm will not be triggered if zones are breached.
|
| 6.1 Entry Delay Timer |
LCD LED |
| |
| Your installer will program designated entry points (i.e. the front door) with an Entry Delay | |
|
| |
|
| Timer. This delay gives you time to enter the armed premises and enter your code to |
|
| disarm your system before the alarm is triggered. |
LCD LED
LCD
LED
6.2Disarming an Armed System
You can only disarm an area to which your user access code is assigned. User access codes with the “Arm Only” (section 7.6 on page 15) option enabled cannot disarm an armed system.
How do I disarm the system?
1.Enter your [ACCESS CODE].
2.Press the [DISARM] button. If you have access to more than one area, select the area(s) you wish to disarm (refer to section 6.2 on page 10).
To disarm a system in alarm:
1.Enter your [ACCESS CODE].
2.In the case of a false alarm, call your monitoring station quickly to advise them of the false alarm.
In the case of a burglar alarm, leave the premises and call the Police from a safe location.
6.3Alarm Memory Display
When an alarm occurs in a zone:
•The area and zone (i.e. Alarm Area 1 - Front Door) are displayed / zone’s LED flashes even when the system is armed. The notification continues until disarming, even if the zone is restored. (EVO641 / EVO641R only)
•The alarm memory will be erased after the next alarm occurs and a valid code has been entered.
To view the alarms that occurred the last time the system was armed:
1.When the system is disarmed, the LCD keypad’s screen will display Alarm in Memory: Press [mem]. The
2.Press the [MEM] button.
Each zone that was breached while armed will appear below Alarm in:.
The MEM action light will flash and the numerical light(s) for each zone whose alarm was triggered will illuminate.
3. Press the [CLEAR] button to exit the Alarm Memory Display.
