Paradyne BitStorm 2600 manual Cables Required, DSL Ports

1. Installation

Cables Required

Table 1-1shows all the cables that may be required for your installation.

Table 1-1. Cable Descriptions

Connector Name	Connector and Cable	For Connecting . . .
DSL PORTS 1–24	50-pin RJ21X Telco-type	Up to 24 DSL ports to Main
	straight connector and 50-wire	Distribution Frame, punchdown
	cable. Two cables required, one	block, or splitters.
POTS 1–24	for DSL and one for POTS (if	Up to 24 POTS splitter ports to
	used).
		Main Distribution Frame or
		punchdown block.
Port 3	SFP Transceiver	An upstream BitStorm 2600 to a
GigE		downstream BitStorm 2600, or a
		downstream BitStorm 2600 to an
Port 3	8-position modular plug and
		upstream BitStorm 2600 or
1000BT	8-wire Category 5 or better	network.
	unshielded twisted pair (UTP)
	cable.
Port 2 10/100BT	8-position modular plug and
	8-wire Category 5 or better
	unshielded twisted pair (UTP)
	cable.
Port 1 10/100BT	8-position modular plug and	A Network Management System
	8-wire Category 5 or better	(NMS) over a Local Area
	unshielded twisted pair (UTP)	Network (LAN) employing
	cable.	10BaseT or 100BaseT.
T1/E1 Ports 1–8	From one to eight 8-position	A BitStorm 2600 to a T1/E1
	modular plug and 8-wire	bridged PPP or MLPPP uplink
	Category 5 or better unshielded	interface.
	twisted pair (UTP) cables.
CONSOLE	DB9 plug connector and	The BitStorm 2600 to one of the
	shielded cable.	following:
	„ The other connector	„ A terminal or a PC with a
	depends on the serial port on	terminal emulation program,
	your terminal or PC, but	or
	normally is a DB9 socket.
	„ The other connector	„ A modem.
	depends on the serial port on
	your modem, but normally is
	a DB25 plug. A null modem
	(crossover) cable is required.
ALARM	5-position terminal block and	The BitStorm 2600 to an alarm
	shielded, twisted-pair cable.	system.

2600-A2-GN20-40 March 2005 1-3