Paradyne BitStorm 2600 manual 10/100BaseT Uplink Port

2. Cabling

PORT1-
10/100BT	PORT2-
	10/100BT	1000BT
			PORT3
			LINK	ACT
	CONSOLE	ALARM

GigE

STATUS ALARM TEST

03-17441

SFP

Transceiver

LC

Connector

2.Connect the other end of the uplink cable to the uplink interface, such as an Ethernet switch.

3.Port 3 (eth3) is the default uplink. If you have changed the default, use the configure uplink CLI command or the Configuration / Uplink screen of the web interface to specify eth3 as the uplink port.

10/100BaseT Uplink (Port 2)

Port 2 can be configured as the uplink for a single BitStorm 2600, or for the terminating unit in a stack of BitStorm 2600s. A straight-through cable can be used regardless of the destination interface, since the port automatically distinguishes between an MDI and an MDIX.

Procedure

To use Port 2 as the uplink:

1.Connect an 8-position modular cable to Port 2.

2.Connect the other end of the cable to the uplink interface, such as an Ethernet switch.

3.Using the configure uplink CLI command or the Configuration / Uplink screen of the web interface, specify eth2 as the uplink port.

2-4 March 2005 2600-A2-GN20-40