Paradyne BitStorm 2600 manual Mounting Configurations, Mounting Brackets

1. Installation

Mounting Configurations

Three basic installation configurations are available:

„Rack mount – see Installing the Brackets for Rack Mounting on page 1-6and Installing the BitStorm 2600 Into a Rack on page 1-8.

„Wall mount – see Installing the BitStorm 2600 on a Wall on page 1-10.

„Shelf or desktop – see Installing the BitStorm 2600 on a Shelf or Desktop on page 1-12.

Mounting Brackets

Your BitStorm 2600 can be installed in a rack or on the wall using mounting brackets. Two brackets suitable for a 19-inch (483 mm) rack (marked EIA-19) and two brackets suitable for a 23-inch (584 mm) Bay Networks or Nortel rack (marked with Paradyne Part Number 868-6282-0020) are shipped with the unit. Two brackets suitable for a 21-inch (535 mm) rack (marked ETSI) are available from Paradyne as a separate feature (see Appendix B, Equipment List).

Rack-mounting brackets may also be used to attach the unit to a wall.

NOTE:

In this guide, the term rack refers to any rack, cabinet, frame, or bay suitable for mounting telecommunications equipment.

Installing the Brackets for Rack Mounting

Procedure

To install the mounting brackets for rack mounting:

1.Locate the black screw nearest the front panel on each side of the unit, as shown.

1	3	5	7
2	4	6	8	9	11	13	15	17
				10	12	14	16		19	21	23
								18	20
										22	24

DSL PORTS 1-24

POTS 1-24

03-17445

2. Remove these two black screws (one from each side) before attempting to install the mounting brackets.

1-6 March 2005 2600-A2-GN20-40