Paradyne BitStorm 2600 manual Connecting a Terminal or PC to the Console Port

2. Cabling

Console Port

The CONSOLE port normally serves as the primary user interface with the BitStorm 2600 during installation. You can connect a terminal or PC directly to the CONSOLE port using a DTE cable (see procedure below). You can also use the CONSOLE port to attach a modem to the BitStorm 2600 for remote dial-in management of the unit using a DCE cable (see Connecting a Modem to the Console Port on page 2-9).

Connecting a Terminal or PC to the Console Port

Procedure

To connect a terminal or PC to the CONSOLE port:

1.Configure the terminal or terminal emulation program to use the following parameters:

—Maximum speed: 9600 bps

—Data bits: 8

—Parity: None

—Flow Control: None

—Stop bits: 1

2.Determine and procure the proper Data Terminal Equipment (DTE) cable type. The CONSOLE port requires a DB9 plug connector. The other connector depends on the serial port on your terminal or PC.

3.Connect the DB9 plug connector to the CONSOLE port socket. The CONSOLE port is ordinarily used only during installation, so do not fasten the connector.

4.Connect the other end of the cable to the serial port of your terminal or PC.

Serial

Port

PORT1-
10/100BT PORT2-
10/100BT	1000BT
		PORT3
		LINK	ACT
	ALARM

GigE
STATUS	ALARM	TEST

1	3	5	7
2	4			9	11	13
		6	8				15	17
				10	12				19	21
						14	16				23
								18	20	22	24

DSL PORTS 1-24

03-17447

2-8 March 2005 2600-A2-GN20-40