WR1500 4-Port Wireless DSL/Cable Router
®
27
Appendix 2 - Troubleshooting the WR1500 Initial
Setup and Installation
This section will assist you in troubleshooting the setup
and installation of your WR1500. Extensive troubleshooting
procedures are included in the manual on the CD ROM.
Problems Starting Up the WR1500 Access Point
Troubleshooting the Start-Up of Your WR1500 Access Point
PROBLEM
PROBLEM
CORRECTIVE ACTION
CORRECTIVE ACTION
None of the LED’s
None of the LED’s
turn on when I
plug in the power
adaptor.
Make sure you are using the supplied
power adaptor and that it is plugged in to an
appropriate power source. Check that the
power source is turned on. If the problem
persists, you may have a hardware problem.
In this case, you should contact your local
vendor.
I cannot access
the WR1500
Access Point via
the console port.
1. Check to see if the WR1500 Access Point is
1. Check to see if the WR1500 Access Point is
1. Check to see if the WR1500 Access Point is
connected to your computer’s console port.
2. Check to see if the
2. Check to see if the
communications program
is confi gured correctly. The
communications software
should be confi gured as
follows:
VT100
terminal
emulation.
9600 bps is
the default
speed on
leaving the
factory. Try
other speeds
in case
the speed
has been
changed.
changed.
No
parity, 8
data bits,
1 stop
bit, data
fl ow set
to none.
Continued next page