Operator's Handbook
Charging the Handles
This procedure tells you how to charge the handle using the wall charger.
WARNING
Inspect the cord for bare wire before each use of the wall charger. Do not use the charger with bare wire.
When using the wall charger or storing it:
∙Do not wrap the cord around the transformer.
∙Do not pull or put unusual stress on the cord.
To recharge the handle while it is on the printer, push the power switch off. Do not use the printer while the handle is charging on the unit.
Handle
(Power Module)
Figure 1
1.Plug the cord of the wall charger into the handle socket (Figure 1).
2.Plug the other end of the cord into a 115V electrical outlet. A full charge takes approximately 8 hours. The handle cannot be damaged by overcharging. Therefore, you can leave charged handle plugged in when not in use.
Areas using 220V, 230V, or 240V will receive a wall charger designed for these voltages.
6
