Ethernet Switch | Pelco C2622M instruction

I N S T A L L A T I O N

	FX82051 Unmanaged
®	Ethernet Switch

Five 10BASE-T/100BASE-TX Ports and One 100BASE-FX Fiber Port

C2622M (2/07)

Image 1

Pelco C2622M manual Ethernet Switch

Contents

Ethernet Switch List of Illustrations ContentsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory Notices Description Product Overview FX82051 module consists of the following series of models ModelsMultimode Models Single-Mode Models*† Front Panel Power LED Pelco badge100BASE-FX Status LED Rear Panel 10BASE-T/100BASE-TX Ports 1-5 RJ-45 connectors Package Contents Installation Flow control is disabled by default Autonegotiation is enabled by default Flow control default setting Table A. TX Mode Switch Settings10BASE-T/100BASE-TX Modes of Operation Mounting the FX82051 Module Into a Rack Mounting Mounting the FX82051 Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsFiber connections Fiber Port Connections in Point-to-Point Application Troubleshooting Meaning Possible Cause Corrective Action Optic Fault LED Desired, refer to Setting Table C. Troubleshooting with Rear-Panel IndicatorsData is being Desired, refer to Setting Transmitted or Amber Meaning Possible Cause Corrective Action Duplex mode Duplex link Duplex modeIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplex Flashing green Port is set to Normal or excessive Green Port is set to If 100BASE-TX full-duplexReplace cable if it is Use Cat5e or higher Table C. Troubleshooting with Rear-Panel Indicators Duplex/collision and speed Specifications FX82051SSTR-2 Optical Maximum Laser Illustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector Pinouts Product Warranty and Return Information ISO9001