Fiber Port Connections in Point-to-Point Application | Pelco C2622M

Figure 7. Fiber Port Connections in Point-to-Point Application

16	C2622M (2/07)

Image 16

Pelco C2622M manual Fiber Port Connections in Point-to-Point Application

Contents

Ethernet Switch List of Illustrations ContentsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Regulatory Notices Radio and Television Interference Product Overview Description Models FX82051 module consists of the following series of modelsMultimode Models Single-Mode Models*† Front Panel Power LED Pelco badge100BASE-FX Status LED 10BASE-T/100BASE-TX Ports 1-5 RJ-45 connectors Rear Panel Installation Package Contents Autonegotiation is enabled by default Flow control is disabled by default Flow control default setting Table A. TX Mode Switch Settings10BASE-T/100BASE-TX Modes of Operation Mounting Mounting the FX82051 Module Into a Rack Mounting the FX82051 Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsFiber connections Fiber Port Connections in Point-to-Point Application Troubleshooting Meaning Possible Cause Corrective Action Optic Fault LED Table C. Troubleshooting with Rear-Panel Indicators Desired, refer to SettingData is being Desired, refer to Setting Transmitted or Amber Meaning Possible Cause Corrective Action Duplex mode Duplex mode Duplex linkIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplex Green Port is set to If 100BASE-TX full-duplex Flashing green Port is set to Normal or excessiveReplace cable if it is Use Cat5e or higher Table C. Troubleshooting with Rear-Panel Indicators Specifications Duplex/collision and speed Optical Maximum Laser FX82051SSTR-2 Appendix. RJ-45 Connector Pinouts Illustrates RJ-45 MDI/MDI-X connector pinouts Product Warranty and Return Information ISO9001