Pentax 430RS Using the Remote Control Unit optional, E04KB33533e.qk 6/6/02 438 PM Page 40 1,1

e04KB335_33e.qk 6/6/02 4:38 PM Page 40 (1,1)

x

z ( )

●Remote control unit battery service life

Up to approximately 30,000 signals can be sent to the camera from the remote control unit. Contact your nearest Pentax service center when battery replacement becomes necessary.

Zoom on the remote controller

Using the Remote Control Unit (optional)

You can take pictures using the remote control F (optional).

The zoom can be changed using the remote control E (optional).

If you press the Zoom button on the remote control unit, the zoom will switch from [Wide] to [Tele] to [Middle].

198

zSet the mode dial to or in Capture mode.

		x Press the		button to display
							198
			on the LCD monitor.
			The self-timer lamp will blink and the
			camera is ready to take pictures.
Taking		c
			the remote control unit.
			Press the shutter release button on			6/10/2002
						11:19
Pictures			The self-timer lamp will blink rapidly and the picture will be
			taken after approximately three seconds.
		Playing Back Images			p.76
	memo	• The buttons on the camera can be used in the same way.

•Please ensure that the remote control unit is no more than 5 meters away from the front of the camera.

•To take a picture immediately after pressing the shutter release

button on the remote control unit, press the button in step x to display on the LCD monitor.

•When the digital zoom function is enabled, the digital zoom can not be operated with the remote control unit, but the digital zoom can be operated by pressing the Zoom button on the camera. However, the camera will revert to optical zoom mode by pressing the Zoom button on the remote control unit.

•The powersaving function can be operated (the self-timer lamp will also go off).

[Wide] edge [Tele] edge

Taking Pictures

40 41