Perle 833IS User Guide 7
Chapter 1: Quick Installation Overview About Installation
This chapter provides an overview of how to install, setup and configure the 833IS.
These are the major steps:
■Preparing the Site for the 833IS
■Setting up and Installing the 833IS Hardware
■Setting up the 833IS LAN Connection
■Configuring the 833IS
■Attaching the 833IS to the Telephone Network
■Verifying Correct Operation of the 833IS
The 833IS can be set up either using the 833IS Windows Based Manager or by
following a "Cisco mode" setup procedure. The Quick Installation Overview will
cover installation via the 833IS Manager. For information on Cisco mode
installation and operation, please refer to "Appendix 5: Cisco Configuration Mode".
This mode is intended only for advanced users previously trained on the operation of
Cisco equipment.
Preparing the Site
For detailed instructions, see “Chapter 2: Site Preparation” .
Before installing, prepare the site for the 833IS by:
■Arranging the installation of telephone services by the carrier.
■Locating the 833IS in an area where:
■There is sufficient clearances in the front and rear of the unit for ventilation.
■Power cords and cables are out of traffic areas.
■The Front Panel is easily visible and accessible.
■Identifying the PC that will be used for installation of the 32 bit Windows
Manager. This PC must be attached to the LAN.
■Extending all telephony and LAN wiring to the location where the 833IS will be
installed.