Installation and Configuration of 833IS with Cisco Configuration Mode
294 Perle 833IS User Guide
Press
Set the value to match your LAN speed set to 4 or 16 Mbps for Token Ring or set to
Auto, 10 or 100 Mbps for Ethernet.
Press
If you have an Ethernet interface on the card installed in slot 1, this panel may be
displayed. Some versions of the 833IS contain a BNC Ethernet interface in addition
to the RJ45 interface. For these units, you can use this panel to override the auto port
detect feature of the 833IS. Once set, the 833IS will no longer try to auto detect this
port, even after a restart of the unit. The only way to re-enable the auto detect feature
is via this menu item.
Set the value to the desired port (RJ45, BNC, or Auto Detect).
Once the IP parameters have been changed, the 833IS is now running with a
minimum configuration containing the new IP Address. You will be prompted to
save this configuration as the startup configuration file so it will be loaded each time
the unit is rebooted. This minimum configuration is required to establish a Telnet/
TFTP session and for downloading firmware and/or configuration files.
Press
If you wish to save your configuration to NVRAM then press Enter.
Press Enter again to confirm the saving of this configuration.
LAN Speed
Port
RJ45
Save Config
Save Config
Confirm