Verifying Connection
38 Perle 833IS User Guide
Manager Status Displays one of the following messages:
No Manager
Displayed if there is no Manager connected to the 833IS.
Manager IP/IPX
Displayed if the Manager is connected to the 833IS and which protocol is used for
communication
Ping #
IP address
If the 833IS receives an IP ping command in Factory Default mode, this message
will display the address of the device that sent the ping command. The count (#) will
increment for each ping received. If you experience difficulty in communicating
with the 833IS from the Manager or Telnet/FTP, you can send a ping command from
a device and verify that the 833IS is receiving it.
LAN Status MAC Address
Displays the burned in MAC address of the 833IS LAN adapter.
Port
Only displayed for an Ethernet interface. Displays the physical port being used to
communicate to the hub. Valid options are: RJ45, BNC.
The BNC option is valid only for versions of the 833IS that contain a BNC port.
Speed
Display the operating speed of the interface. For Token Ring the valid options are
4Mbps or 16Mbps. For Ethernet, the valid options are 10Mpbs or 100Mpbs.
LAN Frames RX
Displays the number of frames received by the 833IS LAN adapter. This should
increment as the unit receives broadcast messages from the network.
LAN Frames TX
Displays the number of frames transmitted by the 833IS LAN adapter. This should
increment as the unit responds to the broadcast messages from the network.