Perle Systems DS1, TS2 manual Default 10 ms Dial

Serial Port Profiles

Idle Timeout Use this timer to close a connection because of inactivity. When the Idle Timeout expires, the IOLAN will end the connection.

Default: 0 seconds so the port will never timeout

Range: 0-4294967 seconds (about 49 days)

Session Timeout Use this timer to forcibly close the session/connection when the Session Timeout expires.

Default: 0 seconds so the port will never timeout

Range: 0-4294967 seconds (about 49 days)

Sessions Strings Controls the sending of ASCII strings to serial devices at session start and session termination as follows;

zSend at Start—If configured, this string will be sent to the serial device on power-up of the IOLAN or when a kill line command is issued on this serial port. If the "monitor DSR" or "monitor DCD" options are set the string will also be sent when the monitored signal is raised.

zRange: 0-127 alpha-numeric characters. Non printable ascii characters must be entered in this format <027>. The decimal numbers within the brackets must be 3 digits long (example 003 not 3).

zSend at End—If configured, this string will be sent to the serial device when the TCP session on the LAN is terminated. If multihost is configured, this string will only be sent to the serial device when the profile is configured as a listen mode connection and after all multihost connections are terminated.

Range: 0-127 alpha-numeric characters. Non printable ascii characters must be entered in this format <027>. The decimal numbers within the brackets must be 3 digits long (example 003 not 3).

zDelay after Send—If configured, a delay time is sent to the device. This delay can be used to provide the serial device with time to process the string before the session is initiated.

Range: 0-65535 ms

Default: 10 ms

Dial In	If the device is remote and will be dialing in via modem or ISDN TA, enable
	this parameter.
	Default: Disabled
Dial Out	If you want the modem to dial a number when the serial port is started, enable
	this parameter.
	Default: Disabled
Dial Timeout	The number of seconds the IOLAN will wait to establish a connection to a
	remote modem.
	Range: 1-99
	Default: 45 seconds
Dial Retry	The number of times the IOLAN will attempt to re-establish a connection with
	a remote modem.
	Range: 0-99
	Default: 2
Modem	The name of the predefined modem that is used on this line.
Phone	The phone number to use when Dial Out is enabled.

85