Petsafe PIG20-11041 Function and Response Table, To Insert and Remove the Battery, Two Colour LED

Step	Prepare the Receiver Collar
	To Insert and Remove the Battery	5A	5B
	Note: Do not install the battery while the Receiver Collar is on your pet.
	This Receiver Collar utilizes a replaceable PetSafe® battery
	(RFA-188).This unique battery is designed to make battery
5replacement easier and increase water protection.
	To activate the collar, insert the battery module (5A). Using the
	edge of the Test Light Tool as shown, turn the battery clockwise
	until the vertical line on the battery is pointed to the “ON”
	position (5B). If the PetSafe® Receiver Collar is not going to be
	used on the pet immediately, leave it in the “OFF” position.
	To remove the battery, turn the battery counter-clockwise using	5C	5D
	the edge of the Test Light Tool as shown (5C, 5D). DO NOT
	attempt to cut into or pry open the battery. Be sure to discard the
	used battery properly.

A replacement PetSafe® battery can be found at many retailers.

Contact the Customer Care Centre or visit our website at

www.petsafe.net to locate a retailer near you.

Two Colour LED

The two colour LED indicator shows good or low battery. Good battery equals 1 flash every 60 seconds with Green LED. Low

battery equals 3 flashes every 60 seconds with the Red LED. If there are no LED lights it is time to change the battery.

To Set the Static Correction Level

Read all steps before attempting to set the Static Correction Level.

1.With the battery installed, press the Correction Level Button and release when the Receiver Indicator Light lights red (5E).

2.The Receiver Indicator Light will emit a number of red flashes representing the Static Correction Level (5F).

3.Increase the Static Correction Level by pressing and releasing the Correction Level Button within 5 seconds of the previous flashes.

The Static Correction Levels increase from 1 to 5. Pushing the Correction Level Button while the Receiver Collar is on level 5 will cause the Receiver Collar to revert to level 1. Refer to the Function and Response Table to choose the Static Correction level that best fits your pet.

5E

5F

The Receiver Collar is equipped to automatically increase the level of Static Correction the longer your pet remains in the Static Correction Zone if the collar is set at level 2 or above.

The Receiver Indicator Light acts as a low battery indicator, flashing every 60 seconds when battery replacement is required. Test your Receiver Collar at least once a month to verify that it is functioning properly. Check that it activates at the Boundary Wire.

Over Correction Protection

In the unlikely event that your pet “freezes” in the Static Correction Zone, this feature limits the static correction duration to 30 seconds.The system locks out further static correction until the pet leaves the Static Correction Zone.

Function and Response Table

Note: Begin training with Static Correction Level 2 and only increase if your pet does not respond to the Static Correction.

Indicator Light Response		Static Correction Level	Receiver Collar Function	Temperament of Pet
1	Red Flash	1	No Static Correction,Tone Only
2	Red Flashes	2	Low Static Correction	Timid
3	Red Flashes	3	Medium Static Correction	Timid or Average
4	Red Flashes	4	Medium High Static Correction	Average or High Energy
5	Red Flashes	5	High Static Correction	High Energy
Flashes 3 Red Flashes		Low Battery
every 60 seconds

www.petsafe.net 9