Petsafe PIG20-11041 manuel dutilisation Install the Boundary Wire, To Bury the Boundary Wire

Step

7

Install the Boundary Wire

To Bury the Boundary Wire

Burying the Boundary Wire is recommended to protect it and prevent disabling the system.

1.Cut a trench 2.5-7.6 cm (1-3 in.) deep along your planned boundary.

2.Place the Boundary Wire into the trench maintaining some slack to allow it to expand and contract with temperature variations.

3.Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the trench. Be careful not to damage the Boundary Wire insulation.

To Attach the Boundary Wire to an Existing Fence

The Boundary Wire of the PetSafe® In-Ground Fence™ can be attached to a chain link fence, split rail fence, or a wooden privacy fence. The Boundary Wire can be attached as high as needed. However, make sure the Boundary Width is set at a high enough range for the pet to receive the signal. If using a Double Loop with an existing fence at least 1 m (3 ft) tall, run the Boundary Wire on top of the fence and return it on the bottom of the fence to get the 1-1.5 m (3-5 ft) separation needed.

•Chain Link Fence (7A): Weave Boundary Wire through the links or use plastic quick ties.

•Wooden Split Rail or Privacy Fence (7A): Use staples to attach Boundary Wire. Avoid puncturing the insulation of the Boundary Wire.

•Double Loop with an Existing Fence: Run Boundary Wire on top of the fence and return it on the bottom of the fence to get the 1-1.5 m (3-5 ft) separation needed.

•Gate (Single Loop) (7B): Bury the Boundary Wire in the ground across the gate opening. Note:The signal is still active across the gate.Your pet cannot pass through an open gate.

•Gate (Double Loop) (7B): Bury both Boundary Wires across the gate opening while keeping them 1-1.5 m (3-5 ft) apart.

7A

WEAVE WIRE INTO FENCE

STAPLE WIRE TO FENCE

STAPLE WIRE

TO FENCE

7B
	SINGLE LOOP
1-1.5 m	1-1.5 m
(3-5 ft)	(3-5 ft)
	DOUBLE LOOP

To Cross Hard Surfaces (driveways, sidewalks, etc.)

•Concrete Driveway or Sidewalk (7C): Place the Boundary Wire in a convenient expansion joint or create a groove using a circular saw and masonry blade. Place the Boundary Wire in the groove and cover with an appropriate waterproofing compound. For best results, brush away dirt or other debris before patching.

•Gravel or Dirt Driveway (7D): Place the Boundary Wire in a PVC pipe or water hose to protect the Boundary Wire before burying.

7C

7D

www.petsafe.net 11