Philips 20PT9007D user manual Parental Control Password

PARENTAL CONTROL - PASSWORD

arental control allows you to block out any channels. A channel blocked by the Parental Control cannot be viewed until a correct password is used to unblock the channel for viewing. Parental control is defaulted without password protection. The first time you use the TV, create a password to activate Parental Control.

NOTE: the following menu illustrations are given for Analog mode only.

Follow these steps for Digital Mode and Analog Mode.

			MAIN MENU
			Exit
Press MENU button on the remote control to			Picture
			Setup
display onscreen menu.
			Parental Control
			Time
Press CURSOR	or	to scroll through the
			PARENTAL CONTROL
onscreen menu until you see Parental Control
highlighted. Press CURSOR or to display			Go back
			V-chip Setting
the PARENTAL CONTROL menu.
			Master Enable
Press CURSOR	or	to scroll through	Child Lock
			Create Password
parental control features until you see Create
Password highlighted. Press CURSOR or			Password
to display its submenu.
			Go back
Press the NUMERIC buttons on the remote control			Create Password	_ _ _ _
			Confirm Password	_ _ _ _
to enter a four-digit password. You are required to
input twice so as to confirm the password.

After you set the password, the PARENTAL CONTROL	PARENTAL CONTROL
,,
,,
menu changes with Create Password being replaced	Go back
,,
,,	V-chip Setting
by Change Password . If you want to set another
password easier for memory, just do as follows:	Master Enable
	Child Lock
	Change Password
Press CURSOR or followed by the
	Password
NUMERIC buttons on the remote control to
enter a new four-digit password twice.	Go back
	New Password	_ _ _ _
	Confirm Password	_ _ _ _

NOTE: Remember this code which you have set. You can use this code to access the Parental Control features in both Digital and Analog mode.

NUMERIC

HELPFUL HINTS

If you forget the password, you can reset it with key combinations:

Put the TV to Standby mode first, then press the VOL- button on the front panel and the Clear button on the remote control at the same time and hold them for 5 seconds.

OK

18