BASIC CABLE BOX/DECODER CONNECTION
If you cable signal uses a cable box or decoder, follow the easy steps below to
complete the connection.
Cable Box Connection (RF Input/Output Only):
Cable Box (w/RF In/Outputs):
This connection will NOT supply Stereo sound to the TV. The sound from the cable box will be mono.
1 Connect the open end of the round Cable Company supplied cable to the cable signal IN(put) plug on the back of the Cable Box.
Jack Panel Back of Cable Box
Cable Signal | 1 | 2 |
|
IN from the |
| ||
Cable |
| ||
Company |
|
|
|
|
| OUTPUT | |
|
|
| CH |
| CABLE | 3 | 4 |
| TO TV |
| |
| IN |
|
|
2 Using a separate round coaxial cable, connect one end to the OUT(put) (TO TV) plug on the back of the Cable Box.
3 Connect the other end of the round coaxial cable to the 75Ω input on the back of the television. Screw it down finger tight.
NOTE: Be sure to set the OUTPUT CHAN- NEL SWITCH on the back of the cable box to CH 3 or 4, then tune the TV to the correspon- ding channel. Once tuned, change channels at
Round 75Ω | 3 | |
Coaxial Cable | ||
|
Jack Panel Back of TV
Cable Box Connection (with Audio/Video Outputs):
the cable box, not the television.
Cable Box (w/Audio/Video Outputs):
This connection will supply Stereo sound to the TV.
4 Connect the open end of the round Cable Company supplied cable to the cable signal IN(put) plug on the back
Cable Signal IN
from the Cable
Company
|
| 4 | Jack Panel Back | ||
|
| ||||
|
| of Cable Box | |||
|
|
|
|
| |
|
|
|
|
|
|
|
| OUTPUT |
| ||
|
|
| CH |
| |
|
|
|
|
|
|
| 3 | 4 |
|
CABLE | TO | VIDEO | L AUDIO R |
IN | TV | OUT | OUT |
Cable Box with
Audio/Video Outputs
24 
of the Cable Box.
5 Using a RCA type Video Cable, connect one end of the cable to the Video (or ANT, your cable box may be labeled dif- ferently) Out jack on the cable box and the other end to the AV1 Video Input on the TV.
6 Using a RCA type Audio Left and Right Cable, connect one end to the left and
right Audio Out L & R jacks on the
cable box. Connect the other end to the AV1 Audio L & R Input jacks on the TV.
NOTE: Use the Channel +, or – buttons on the TV remote control to tune to the AV1 channel for the cable box signal. Once tuned, change channels at the cable box, not the television.
Video Cable |
|
| RCA type Audio |
|
|
| |
5 |
|
| Left and Right |
|
| Cables | |
|
|
| |
Monitor out | AV1 in | AV2 in |
|
VIDEO |
|
|
|
L/Mono | Y |
|
|
|
|
| |
AUDIO | Pb |
|
|
|
|
| |
R | Pr |
| 6 |
COMPONENT VIDEO INPUT | |||
|
|
| |
Jack Panel Back of TV
8
