Add devices
After connecting devices, assign the device attached to each connector.This allows you to easily identify devices connected to yourTV.
1Press (Home).
2Select [Add new device] and press .
3Press or to select a device. Press .
4Press or to select the conector your device is connected to. Press .
5If available, press or to select the audio connector your device is connected to. Press .
6Switch on your device and check for video and audio output.
7If there is video and audio output, press
.
Repeat the procedure until all devices are correctly assigned to connectors.
Use Philips EasyLink
Your TV supports Philips EasyLink, which | English |
| |
uses the HDMI CEC (Consumer Electronics |
|
Control) protocol. |
|
that are connected through HDMI connectors |
|
can be controlled by a single remote control. |
|
Note
•Philips does not guarantee 100% interoperability with all HDMI CEC devices.
Note
•The
EasyLink features
When you connect your TV to devices that support
When you connect your TV to devices that support standby, you can use your TV remote control to put your TV and all connected HDMI devices in standby mode.
System audio control
When you connect your TV to HDMI CEC compliant devices, your TV can switch automatically to play audio from the connected device.
To use
You can use the remote control from the connected device to adjust the volume. Remote control (RC) key forwarding RC key forwarding allows you to control
EN 23