Philips 765 manual Synchronized digital recording from an, external CD player - CD-SYNC, Recording

RECORDING

Note: AUTO TRACK works only with Consumer Sources with a digital output signal according to the IEC 958 (consumer part) audio standard.

Start digital recording

1With the recorder stopped, press RECORD to enter the Record standby mode.

‹ RECORD flashes.

RECORD		ERASE	TRACK OVER		DUAL	TRACK
	CD SYNC			SRC
FINALIZE
DUBB 1	SHUFFLE SCAN			SHUFFLE
AUTO TRACK		TOTAL REM	TRACK TIME	TOTAL REM TRACK TIME

Synchronized digital recording from an

external CD player - CD-SYNC

RECORD

CD

TRACK

DUBB 1

SYNC

OVER

CD-

SCAN

TRACK

SYNC

DU

BB

AUTO/M

TOTAL

REM

TIME

TOTAL

PAUSE

REM

TIME

OPEN

DIG

CD

REWRITABLE

REPEAT 1

C

LOSE

PAUSE

REPEAT 1

C O M

P A C

D

T

S C

DISPLAY

SOURCE

I

R E

C

O R

D E R

C D R

7 6

5

REC

LEVEL

DUAL

DISPLAY

PHONES

English

•If DIG also flashes, the digital connection is incorrect.

2To start recording, press PLAY on the CD Recorder/Player and immediately start the source (from the stop mode).

‹RECORD lights continuously. The track number and recording time used will be indicated on the display.

•To record a three-second pause (silence) at the beginning of a track, press PAUSE on the CD Recorder/Player.

•To check the (remaining) recording time, press DISPLAY. (This can also be done during the recording.)

3To stop recording, press STOP on the CD Recorder/Player.

‹RECORD will go out.

•To interrupt recording, press PAUSE.

‹RECORD starts to flash. Resume at step 2.

After recording the display will show UPDATE for several seconds.

Note: With AUTO TRACK on, the recorder will stop automatically. Recordings from DAT or DCC will stop after 20 seconds silence. With AUTO TRACK off, the AUTO STOP mode is disabled.

Preparing for synchronized digital recording

The CD-SYNC feature enables you to make fast and easy digital recording of a CD. Track increments are automatically detected from the digital source material. Track increments cannot be added manually.

1Make sure the disc is absolutely free of scratches and dust particles.

2Press SOURCE repeatedly until (depending on the connection used):

‹DIG DIGITAL or DIG OPTICAL will appear on the display.

•If necessary, press DUAL to switch off the DUAL mode; DUAL will no longer appear on the display.

				TRACK OVER			TRACK
	RECORD		ERASE			DUAL
		CD SYNC			SRC
	FINALIZE
DUBB 1		SHUFFLE SCAN			SHUFFLE
	AUTO TRACK		TOTAL REM	TRACK TIME	TOTAL REM TRACK TIME

Start synchronized digital recording

1With the CD Recorder/Player stopped, press CD-SYNC.

‹ On the display, CD-SYNC& SYNC appear. After a time,

RECORD starts to flash.

	RECORD		ERASE	TRACK OVER		DUAL	TRACK
		CD SYNC			SRC
	FINALIZE
DUBB 1		SHUFFLE		SCAN	SHUFFLE
	AUTO TRACK		TOTAL REM TRACK TIME		TOTAL REM TRACK TIME
PAUSE DIG			ANALOG	OPT PROG REPEAT 1	PAUSE PROG		REPEAT 1

•If DIG also flashes, the digital connection is incorrect.

2To start recording, press PLAY on the external digital source.

‹The CD Recorder/Player automatically starts to record and RECORD lights continuously. The track number and recording time used will be indicated on the display

•If you start the source during a track, CD-SYNC will not start recording until the beginning of the next track.

15