Philips BDL4211C, BDL4211V, BDL4211P User Manual BDL4211x, Installation Locations, General Faqs

User Manual BDL4211x

2.2INSTALLATION LOCATIONS

•Avoid exposure to heat and extreme cold.

•Do not store or use the product in locations exposed to heat, direct sunlight or extreme cold.

•Avoid moving the product between locations with large temperature differences. Choose a site that falls within the following temperature and humidity ranges.

−Temperature: +5°C…40°C (41°F…104°F)

−Humidity: 20%…80% RH

•Do not subject the product to severe vibration or high impact conditions. Do not place the product inside a car boot.

•Take care not to mishandle this product by either knocking or dropping during operation or transportation.

•Do not store or use the product in locations where there is a high level of humidity or in dusty environments. Do not allow water or other liquids to spill on or into the product.

2.3GENERAL FAQS

Q:When I install my monitor what should I do if the screen shows 'Cannot display this video mode'?

A: Recommended video mode is 1366x768 @60Hz.

Perform the following procedure to adjust the correct resolution:

1.Unplug all cables, then connect your PC to the monitor you used previously, which displayed correctly.

2.In the Windows Start Menu, select Settings/Control Panel. In the Control Panel Window, select the Display icon. Inside the Display Control Panel, select the 'Settings' tab. Under the settings tab, in a box labeled 'desktop area', move the slide bar to 1366x768 pixels.

3.Open 'Advanced Properties' and set the Refresh Rate to 60Hz, then click OK.

4.Restart your computer and repeat steps 2 and 3 to verify that your PC is set at 1366x768@60Hz.

5.Shut down your computer, disconnect your old monitor and reconnect your Philips LCD monitor.

6.Turn on your monitor and then turn on your PC.

Q:What are the .inf and .icm files on the set-up disk & CD-ROM? How do I install the drivers (.inf and Icm)?

A:These are the driver files for your monitor. Follow the instructions in your user manual to install the drivers. The computer may ask you for monitor drivers (.inf and Icm files) or a driver disk when you first install your monitor. Follow the instructions to insert the driver disk (either floppy or CD-ROM) included in this package. Monitor drivers (.inf and Icm files) will be installed automatically.

5