Philips CCZ256AT Turning On the TV/VCR, You cannot set up channels if you are using a Cable Box

CCZ256comb.QX33 4/6/99 9:13 PM Page 8

8 Turning On the TV/VCR

Before you turn on the TV/VCR, make sure there are batteries in the remote control and the TV/VCR is hooked up correctly.

The instructions on this page work only when you turn on the TV/VCR for the first time.

1

1	POWER		EJECT
	SLEEP	SPEED	MEMORY
	REC/OTR		PAUSE/STILL

Press the POWER button. The TV/VCR will come on and the screen shown below will appear.

SELECT LANGUAGE

1 ENGLISH ON

2 ESPAÑOL

MAKE SELECTION OR

PRESS EXIT TO CONTINUE

2

3

2

PLAY

REW

STOP

MENU
	STATUS/EXIT

1 2 3

4 5 6

7 8 9

A.CH 0 +100

CABLE/DBS COMBI

F.FWD

CLEAR

CH.

VOL.

4

5

Press the Number 1 button to select English on-screen displays or press the Number 2 button to select Spanish on-screen displays.

3

Press the STATUS/EXIT button. The screen shown below will appear.

CONNECT ANTENNA OR CABLE

TO TVCR

THEN PRESS B

TO END PRESS EXIT

4

Press the F.FWD/ B button to begin automatic channel setup. The TV/VCR will memorize all available channels. When channels are set, CHANNELS ARE SET will appear on-screen briefly. Then the TV/VCR will go to the lowest channel pro- grammed.

5

Use the CH(annel). Up/Down buttons or the Number buttons on the remote control to select a TV/VCR chan- nel. Use the VOL(ume). Up/Down buttons to adjust the

	VCR PLUS+
VAR.SLOW	/ENTER	MUTE
TRACKING	F.ADV	SLOW

SMART SMART SKIP INDEX

PICTURE SOUND SEARCH SEARCH

Helpful Hints

•If you do not see any on-screen dis- plays when you turn on the TV/VCR, check your hookups, then try again. If you still do not see any on-screen displays, follow the steps on pages nine - 10 to select a language and set up channels.

•To skip step 2, press the STATUS/EXIT button. All on-screen displays will be in English. To skip step 4, press the STATUS/EXIT but- ton. Channels will not be set up, and CHANNELS NOT SET will appear on-screen briefly.

•You cannot set up channels if you are using a Cable Box.

•Line Input mode will always be stored in the TV/VCR’s memory as channel 00. When you select chan- nel 00, A/V IN will appear on- screen briefly. Press the CH(annel). Up/Down buttons or Number but- tons to select another channel.