Registration
Up to 5 handsets can be registered to the base station.
Warning : If you wish to register non Philips handsets to the DECT 623 or DECT 627 base station, make sure that this handset is GAP compliant otherwise it will not operate properly (see page 11).
To register a handset
If you have inadvertently unregistered your handset, you can register it again. Additional handsets must be registered to the base before use.
To register a handset, first press the paging key 
on the base for approx. 5 seconds when the base is in idle mode.Then carry out the following steps on the handset within one minute :
Press to reach the menu list.
Scroll to Adv. Settings and press | SELECT. |
|
Scroll to Registration and press | SELECT. |
|
Enter the | OK. | |
If the registration was successfull, a long confirmation tone is heard and the handset number (1 to 5) will be assigned by the base automatically.
To unregister a handset
Press to reach the menu list.
Scroll to Adv. Settings and press 
SELECT.
Scroll to Unregistration and press 
SELECT.
Choose the handset to unregister from the list and press 
SELECT.
Note : If you have your handset serviced, please make sure it is unregistered from the base station befo- re taking it back to the repair centre.
To reset to default settings
You can reset your phone to the default settings (see page 51) at any time. Note that after a reset all your personal settings and saved data (phonebook entries, SMS messages, call log and redial list) will be deleted.
Press to reach the menu list.
Scroll to Adv. Settings and press 
SELECT.
Scroll to Reset and press 
SELECT.
Select Yes to reset your phone and press 
SELECT.
Note : After a reset you need to reconfigure your phone, refer to page 40.
Advanced Settings | 43 |
