3.3Install
Press B on the remote control and wait a few seconds to switch the receiver on.
The receiver is on: the LED is green.
The receiver is in standby mode: the LED is red.
During a software loading: the LED is blinking.
At the first installation, the First Time Installation window appears:
Highlight the Country field using the arrow key 
.
Select the desired language using the arrow key 
or 
.
Note
Read the information messages displayed on the screen.They will help you to set the correct values.
Highlight Postcode using the arrow key 
. Press OK and enter your postcode.
Then successively set the desired values. In doing so, observe the following:
•By using the arrow key 
or 
, you switch between the individual setting possibilities.
•By using the arrow key 
or 
, you change the displayed values.
•
Then highlight the OK field using the arrow key 
, and press OK.
The Automatic Search window is displayed:
If desired, change the values for the Start and End Frequency using the arrow key 
or 
.
Note
The displayed values for the Start and End Frequency can normally be maintained.
Using the arrow key 
or 
, you define the channels to be searched for: All channels or channels that are Free to air only.
Then highlight the OK field using the arrow key 
, and press OK to start the channel search.
The window displayed provides information on the progress of the channel search.
Note:
By pressing EXIT, you can stop the scan mode at any time.
10 | Getting started |
