Philips DVP3050V Videotape Recording, Recording Prevention, To stop recording, press Stop C

H9821MD_DFU_EN1_0214 2/14/05 11:14 AM Page 22

English

22Videotape Recording

Read and follow the steps below to record a television program onto a videotape.

●Before you begin, make sure the DVD/VCR is in VCR mode. Press VCR so VCR light appears on the front of the DVD/VCR.

1 Turn on the TV and set it to channel 3 or 4 or the Video In channel. If you connected the DVD/VCR to the TV using the supplied audio and video cables, select your TV’s Video In channel. Details are on page 10.

If you connected the DVD/VCR to the TV using the supplied RF coaxial cable, choose channel 3 (or 4) at the TV. Details are on pages 7-9.

2 Insert a tape with its record tab intact into the cassette compartment of the DVD/VCR. If tape playback begins, press STOP C.

3 Press SPEED until the desired tape speed (SP or SLP) appears briefly on the screen. Details about tape speed are on page 58.

4 Press SKIP ∑/CH K or SKIP w/CH L or the

Number buttons to select the TV channel to record.

5 Press RECORD I to start recording. “REC” will appear on the DVD/VCR’s display panel.

6 To pause the recording, press PAUSE k once. “REC” will flash. To resume recording, press RECORD I or press PAUSE k again. “REC” will reappear.

7 To stop recording, press STOP C.

Recording Prevention

Video cassettes have record tabs to ensure that recordings are not accidentally erased.

1 To prevent recording, break off the tab with a screwdriver.

2 To allow recording, cover the hole with clear tape.

Remove the	Cover the
tab to prevent	hole to allow
recording.	recording.

1 Turn on the TV.

2 Insert a tape in the DVD/VCR.

			STANDBY-ON
	SEARCH	MODE	DISPLAY
	REPEAT REPEAT		AUDIO		4
		A-B
	SUBTITLE	ZOOM	ANGLE	SKIP / CH
	RETURN	TITLE CLEAR/RESET SLOW
	VCR	VCR/TV		DVD
	DISC/VCR			SYSTEM
	MENU			MENU
7		OK			6
	STOP	PLAY		PAUSE
	TIMER SET	MARKER		RECORD
3	SPEED
		1	2	3
	4	5	6	7
4	8	9	0	+10

5-6

Helpful Hints

•Other recording options are on pages 23-28.

•The VCR will record in a preset volume.

•Pause will switch to Stop after 5 minutes to protect the VCR and the tape from damage.

When a recording is paused, review the pause time remaining with the ■ marks on the screen. Each ■ mark equals

1 minute remaining. During the last minute of paused recording, the ■ mark will flash.

•If any menu is on the TV screen, RECORD I on the remote does not function. Press CLEAR/RESET to remove the menu.Then, press RECORD I. Or, use RECORD I on the front of the DVD/VCR.