English

-Do not let the mains cord and supply hose come into contact with the hot soleplate of the iron.

-If steam escapes from under the Calc-Clean rinsing cap when the appliance heats up, switch off the appliance and tighten the Calc-Clean rinsing cap. If steam continues to escape when the appliance heats up, switch off the appliance and contact a service centre authorised by Philips.

-Never remove the Calc-Clean rinsing cap when the steam tank is hot.

-Do not use any other cap on the steam tank than the Calc-Clean rinsing cap that has been supplied with the appliance, as this cap also functions as a safety valve.

Caution

-Only connect the appliance to an earthed wall socket.

-Check the mains cord and the supply hose regularly for possible damage.

-Always place and use the iron and the steam tank on a stable, level and horizontal surface.

-The iron stand and the soleplate of the iron can become extremely hot and may cause burns if touched. If you want to move the steam tank, do not touch the stand.

-When you have finished ironing, when you clean the appliance and also when you leave the iron even for a short while: put the iron on the iron stand, switch off the appliance and remove the mains plug from the wall socket.

-Rinse the steam tank regularly according to the instructions in the chapter ‘Cleaning and maintenance’.

-This appliance is intended for household use only.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today.

Before first use

1Remove any sticker or protective foil from the soleplate and clean the soleplate with a soft cloth.

2Fully unwind and straighten the mains cord and supply hose.

3Place the steam tank on a stable, level surface.

4Place the iron on the iron stand.

Preparing for use

Filling the water tank before use

Note:You can fill the water tank at any time, also during use (see section ‘Refilling the water tank’).

Never immerse the steam tank in water. Do not put perfume, vinegar, starch, descaling agents, ironing aids or other chemicals in the steam tank.

1Open the filling funnel lid (Fig. 2).

2Fill the water tank with tap water up to the maximum level (Fig. 3).

Note: If the tap water in your area is very hard, we advise you to mix it with an equal amount of distilled water, or to use distilled water only.

3Properly close the filling funnel lid (‘click’).

Do not tilt or shake the steam tank when the water tank is full. Otherwise water may spill out of the filling funnel.

Page 7
Image 7
Philips GC7230 English, Electromagnetic fields EMF, Before first use, Preparing for use, Filling the water tank before use