Philips 525p, HTS6520/93, 625p user manual Turn on Progressive Scan, Use Philips EasyLink

Turn on Progressive Scan

If theTV supports progressive scan output, you can connect this HomeTheater System and theTV using component video connection. (see ‘Connect video cables’ > ‘Connect to the component video jack’).

Video Setup

TV System
	On
TV Display	Off
Picture Setting
HDMI Setup
Closed Caption
Progressive

1Turn on the TV and ensure that the TV progressive scan mode is deactivated (see the TV user manual).

2Switch the TV to the correct viewing channel for this Home Theater System.

3Press DISC.

4PressSETUP.

5Pressto select [Video Setup] in the menu, then press .

6Select [Progressive] > [On], then press

OK.

» A warning message is displayed.

7To proceed, select [Ok] and press OK. » The progressive setup is complete.

Note

•If a blank/distorted screen is displayed, wait for 15 seconds for the auto recover.

•If no picture displayed, turn off the progressive scan mode as follows: 1) Press to open the disc compartment. 2) Press . 3) Press

AUDIO SYNC.

8Press SETUP to exit the menu.

9You can now turn on the progressive scan mode on the TV.

Note

•During play, when progressive scan mode is on for both this Home Theater System and the TV, distorted picture may display. Turn off the progressive scan feature on both this Home Theater System and the TV.

Use Philips EasyLink

Your HomeTheater System supports Philips EasyLink, which uses the HDMI CEC (Consumer Electronics Control) protocol. EasyLink-compliant devices that are connected through HDMI connectors can be controlled by a single remote control.

Note

•Philips does not guarantee 100% interoperability with all HDMI CEC devices.

1 Turn on the HDMI CEC operations on the TV and other connected devices. See TVs/devices manual for details.

2You can now enjoy the following Philips EasyLink controls.

EasyLink

You can turn off or turn on all EasyLink features.

One-touch play

When you connect your Home Theater System to devices that support one-touch play, you can control your Home Theater System and the devices with one remote control. For example, when you press Play on your DVD remote control, your TV automatically switches to the correct channel to show the DVD content.

To enable One-touch play, a video disc must be placed in the disc compartment before operation.

English

Get started

EN 23