17
When Setting from the DHCP Server
If the administrator manages the network at the DHCP server, each address is
automatically assigned from the DHCP server. Proceed to

When Setting from the

DHCP Server in Step 1

on page 18.
When Setting by Direct Entering
If the administrator manages the IP address, contact your network administrator to
confirm the values before the setup. If not, set the unique value that is not used for any
other device on the network by referring to the example shown below. After setting up
the IP address, proceed to

When Setting by Direct Entering in Step 1

on page 19.
Example: How to assign the IP address, Subnet Mask and Default Gateway values.
IP Address: 10.x.x.x (For x, you can choose any number from 0 - 255 except
0.x.x.x and 255.255.255.255)
Be sure that the IP address is not already assigned to any other
device.
Subnet Mask: 255.000.000.000
It is the same value with all devices.
Gateway: Not required.
Note: It is recommended to select “IPX Peer-to -Peer printing using IPX protocol” if you
have trouble setting up the IP address values. Its settings are comparatively easy.