4Lightly wipe the upper side of the scanner glass (A) and the lower side of the document feeder/scanner film (= white plastic plate) (B) with a cloth.
EN
5Clean the feed roller (A) and the underside of the sup- port pad of the feeder roller (B) with a soft,
6Close the scanner cover and the cover of the automatic document feeder. Both the supports must securely snap into place.
7Turn the blue gear wheel forward to tension the ink film. The ink film must not have any creases.
8Close the device. Insert the paper tray in the opening provided for it behind the paper feeder. Insert paper again.
Checking the Firmware Version
1Press OK, 47 and OK.
2The model designation and the configured country ap- pear on the display.
3Confirm with OK.
4The information on the firmware version of the device is displayed.
5Confirm with OK.
Using Service Codes
The service codes delete all the changed settings and your device is reset to factory settings. It may be possible that the device with the changed settings reacts differently than ex- pected.
Only use the service codes if this is absolutely neces- sary. Some service codes also delete saved messages and telephone book entries.
1Press OK, 45 and OK.
2Enter a service code:
3Confirm using OK.
4Dial using [ SURE: YES.
5Confirm using OK.
If you have entered the incorrect code, you can cancel the entry with SURE: NO.
Power Cycling
If a problem occurs that cannot be corrected with the in- structions in this user manual (see also the help below), fol- low the steps given here.
1Pull out the power plug.
2Wait at least ten seconds, then plug the power plug back into the socket.
3If the error occurs again, please contact our technical customer service or your retailer. Follow the instruc- tions on the display and on the error report.
26 | Philips PPF 631 · 632 |
