Preparations
English
IMPORTANT!
–Make sure to complete the preparation procedures before operating the system.
Step 1: Inserting batteries into the remote control
1Open the battery compartment.
2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by “+” and
3Close the cover.
Using the remote control to operate the
system
1Point the remote control directly at the remote
sensor (iR) on the front panel.
2Select the source you wish to
control by pressing one of the source select buttons on the remote control (for example TAPE,TUNER).
3 Then select the desired function (for example 2;, í, ë).
CAUTION!
–Remove batteries if they are exhausted or will not be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed of properly.
Step 2: Setting the clock
1In standby mode, press and hold CLOCK SET/ RDS on the system.
➜ “SET CLOCK” appears.Then, the clock digits for the hours flash.
2Press TUNING S T on the system to set the hours.
3Press CLOCK SET/RDS again.
➜ The clock digits for the minutes flash.
4Press TUNING S T on the system to set the minutes.
5Press CLOCK SET/RDS to confirm your setting.The system will store the setting automatically.
➜ The time setting becomes effective.
Note:
–The clock will be cancelled when the power cord is disconnected or if a power failure occurs.
–During setting, if no button is pressed within 30 seconds, the system will exit clock setting mode automatically.
20
