| English 13 |
Question | Answer |
Why does the LINK | It flashes red because there is no connection.The parent unit may be out |
light flash red? | of range of the baby unit or may be set to a different channel than the |
| baby unit. Check if the parent unit and the baby unit are both set to the |
| same channel. If they are, put the parent unit in a different place, closer |
| to the baby unit. If they are not, set both units to the same channel and |
| wait |
Why does the parent | What you hear is the link alert. It indicates that there is no connection |
unit beep? | between the baby unit and the parent unit.The parent unit may be out |
| of range of the baby unit or may be set to a different channel than the |
| baby unit. Check if the parent unit and the baby unit are both set to the |
| same channel. If they are, put the parent unit in a different place, closer |
| to the baby unit. If they are not, set both units to the same channel and |
| wait |
Why does the parent unit react too slowly to the baby’s sounds?
Why does the parent unit react too quickly to other sounds?
Why can’t I establish a connection?
Set the microphone sensitivity on the baby unit to a higher level and/or move the baby unit closer to the baby. Make sure the baby unit is at least 1 metre/3 feet away from the baby.
Set the microphone sensitivity on the baby unit to a lower level and/or move the baby unit closer to the baby. Make sure the baby unit is at least 1 metre/3 feet away from your baby.
The units may be set to different channels. Set both units to the same channel and wait
The baby unit may be out of range of the parent unit or there may be too many walls and/or ceilings between the two units.Try a different location or reduce the distance between the two units.
Why is the | The parent unit is probably close to the boundaries of the operating |
connection lost every | range. Put the parent unit closer to the baby unit in a place where it has |
now and then? | better reception. Please note that it takes about 30 seconds before the |
| connection is |
| The baby unit may be out of range of the parent unit or there may be |
| too many walls and/or ceilings between the two units.Try a different |
| location or reduce the distance between the two units. |
Why do I get | You may get interference when the parent unit is out of range of the |
interference on the | baby unit.The parent unit may also be too close to a window and pick |
parent unit? | up interfering signals through this window. Move the parent unit away |
| from the window. |
| Interference also occurs if there are too many walls or ceilings between |
| the parent unit and the baby unit. Put the parent unit in a different place, |
| closer to the baby unit. Also make sure the units are well away from |
| mobile or cordless phones, radios or TVs. |
Why do I hear noise | There may be interference from another appliance or baby monitor. |
or a scratching sound? | Switch both units to another channel. Make sure both units are set to |
| the same channel. |
| The parent unit may be too close to a window, causing it to pick up |
| signals from other appliances or baby monitors. Move the unit away from |
| the window. |
