Philips SCD481 manual Using the appliance

8English

2Insert four non-rechargeable batteries (Fig. 4).

Note: Make sure the + and - poles of the batteries point in the right direction.

3Reattach the lid and turn the locking knob clockwise with a coin or screwdriver.

Note:When the batteries are low, the power-on light on the baby unit flashes red.

Parent unit

The parent unit runs on a rechargeable battery pack (included).

Charge the parent unit before you use it for the first time or when the power-on light on the parent unit flashes red to indicate that the battery pack is low.

1Slide the lid of the compartment for the rechargeable pack downwards to remove it (Fig. 5).

2Insert the plug of the rechargeable battery pack into the socket inside the compartment (1). Then put the rechargeable battery pack into the compartment (2) (Fig. 6).

Make sure your hands and the unit are dry when you insert the rechargeable battery pack.

3

4

,,

5

,,

--

--

Slide the lid back onto the parent unit.

Place the parent unit in the charger (1), put the small plug in the charger and put the adapter in a wall socket (2) (Fig. 7).

During charging, the charging light on the charger lights up red continuously.

Leave the parent unit connected to the mains until the battery pack is fully charged. When the battery pack is fully charged, the charging light gradually dims.

When you charge the parent unit for the first time or after a long period of disuse, switch it

off and let it charge continuously for at least 14 hours.

When the battery pack is fully charged, the parent unit can be used cordlessly for up to 10 hours.

Note:When the parent unit is charged for the first time, the operating time is less than 10 hours.The battery pack only reaches its full capacity after you have charged and discharged it three times.

Note:When the battery pack is low, the power-on light on the parent unit flashes red.

Note:When the battery pack is completely empty, the parent unit automatically switches off and loses contact with the baby unit.

Note:When the parent unit is not connected to the mains, the battery pack gradually discharges, even when the parent unit is switched off.

Using the appliance

1Place the two units in the same room to test the connection (Fig. 8). Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.

2Press and hold the on/off button 3 on the baby unit until the green power-on light goes on.  (Fig. 9)

3Turn the volume control to switch on the parent unit and to set the volume to the level you prefer (Fig. 10).

,, The green power-on light goes on.

,, The LINK light on the parent unit flashes green until connection has been established. This takes up to 30 seconds.The LINK light on the parent unit then lights up green continuously.

Note: If no connection can be established, the LINK light on the parent unit flashes red.

4Place the baby unit at least 1 metre/3 feet away from your baby (Fig. 11).