Philips TTX400 manual TTX410 optional

TTX400

TL5/TL-D

Pre-wired TTX400 trunking with 5-

wire ribbon cable

Pre-wired TTX400 trunking with 7-

wire ribbon cable

Light-line systems

TTX410 (optional)

TTX410 is the unwired trunking section that allows the electrical units to be mounted in any desired position. On the upper part of the trunking section, special knock-out openings enable cable entry.The mains connection can be made with the 7-pole connector ZTX410 TC. Electrical connection to the electrical unit can be made with a 5-pole contact block with insert contacts (ZTX400 DC).These connection blocks can be installed at any place inside the trunking sections.The required wiring can be fixed inside the trunking section by using internal cable clips (ZTX410 IC).When electrical units are used with conventional or low-loss ballasts, H07GU (110 ºC) cables should be

used.When electronic ballasts are used, H07VU (70 ºC) cables are sufficient.The TTX410 unwired trunking sections are delivered with the mechanical coupling piece.This unwired system is also well suited to mounting waterproof or surface-mounted luminaires.

TTX400 CM-CU

TTX400 491 7 CM-CU-PI is a 1-length 58 W trunking section with a 7-pole connector. It is a universal and flexible piece for mains supply entry at the beginning or middle of the light-line. It is an alternative to ZTX400 CU,TTX400 CU7 or ZTX400 CM.

		TTX400 TL-D
		Standard trunkings
Type		TTX410 (unwired)
Length		2 x or 3 x length of electrical unit 58 W (582 or
	583)
Material		Steel, prelacquered white
Accessory		Connection units, suspension/mounting brackets,
		external coupling piece, etc, see TTX400 accessory
		section

Where relevant, for detailed descriptions of Lighting Controls we refer you to chapter 11, and descriptions for e.g. optics/optical covers, lamps data, photometrical diagrams, etc. to the respective sections in chapter 12.

Unwired TTX410 trunking

Philips indoor luminaires Light-line systems 8.55