Philips TTX400 manual Maxos TL-D IP64 electrical units, Inductive, High Frequency Performer HFP

Maxos

Maxos TL-D IP64 electrical units

The IP64 electrical units are designed for quick and reliable mounting in Maxos IP64 trunking sections.They are made of steel with a white powder finish.

The high IP classification is possible due to special seals between the trunking sections and to lamp holders with gasketted screw rings on the IP64 electrical units. Maxos IP by is not designed for applications in regular humid environments.

A connector block is mounted for electrical connection to the trunking.The electrical units are equipped with electronic ballasts (including dimmable and DALI) or low-loss conventional ballasts.The conventional ballasts are available as parallel compensated (IC) or

	Maxos TL-D
	IP64 Electrical units
	(to be used with IP64 trunking only)
Type	4MX091
Lamp	Fluorescent:
	1 x or 2 x MASTER TL-D / G13 / 36, 58 W
Gear	Electro magnetic (low loss), 230 or 240 V / 50 Hz:
	Inductive (I)
	Inductive, parallel compensated (IC)
	Electronic, 220 - 240 V / 50 - 60 Hz:
	High Frequency Performer (HFP)
	High Frequency Regulator (HFR)
Option	Emergency lighting:
	1 hour (EL1), 3 hours (EL3)

inductive (I).The units can hold 1 or 2 TL-D lamps. Dimmable versions are delivered with HF-R electronic ballast, allowing the light output of the TL-D lamps to be regulated from 3 to 100%. HF-R and HF-DALI units must be mounted to 7-wire trunking sections.

The electrical units can be combined with dedicated IP64 trapeze reflectors and a selection of aluminum reflectors.These aluminum reflectors offer a choice of narrow-beam, asymmetrical-beam and very-narrow-beam light distributions for 1 x 58 W. Units which comply with the FF rules (limited surface temperature) are available on request. Special electrical units equipped with an emergency battery pack for 1 or 3 hours (EL1/EL3) are available.These units must be used with 7-wire trunking sections.

Material	Sheet steel in white (WH)
Accessory	Protection tube
Remarks	Not for permanent wet conditions, corrosion
	possible over time
	To be used with standard trapeze reflectors
	(1-lamp) or dedicated IP64 trapeze reflectors
	(2-lamp) or dedicated aluminum reflectors (on
	request)

Light-line systems

Where relevant, for detailed descriptions of Lighting Controls we refer you to chapter 11, and descriptions for e.g. optics/optical covers, lamps data, photometrical diagrams, etc. to the respective sections in chapter 12.

Maxos 4MX091 TL-D IP64 1-lamp

electrical unit

Maxos 4MX091 TL-D IP64 2-lamp

electrical unit

Philips indoor luminaires Light-line systems 8.27