Philips TTX400 manual Maxos electrical units

Maxos

Maxos electrical units

The electrical units for Maxos trunking sections can hold 1 or 2 TL5 or TL-D lamps and are designed for quick and reliable click-in mounting.They are made of steel with a white or silver coating.

The electrical units can be equipped with HFP electronic ballasts, HFR dimming ballasts (allowing light output of a TLD-lamp to be regulated from 3 to 100%), HF-DALI ballasts or low-loss conventional ballasts.

HFR and HF-DALI units must be mounted to 7-wire trunking sections. The conventional ballasts are available parallel compensated (IC) or inductive (I).

Special electrical units equipped with an emergency battery pack for 1 or 3 hours (EL1/EL3) are available.These units must be used with

7-wire trunking sections. If trunkings with double wiring are used, one flat ribbon cable will be connected to the central battery.This provides a completely separate emergency lighting circuit.

Some 2-lamp TL-D reflectors need dedicated electrical units (F32) with a short distance between the lamps. On request, the TL-D electrical units can be upgraded from IP20 to IP40 with an IP40 set that is available as an accessory.

	Maxos TL5		Maxos TL-D
	Electrical units		Electrical units
Type	4MX691	Type	4MX091
Lamp	Fluorescent:	Lamp	Fluorescent:
	1 x or 2 x MASTER TL5 / G5 / 35, 54, 49, 80 W		1 x or 2 x MASTER TL-D / G13 / 36, 58 W
Gear	Electronic, 220 - 240 V / 50 - 60 Hz:	Gear	Electro magnetic (low loss), 230 or 240 V / 50 Hz:
	High Frequency Performer (HFP)		Inductive, parallel compensated (IC)
	High Frequency Regulator (HFR)		Electronic, 220 - 240 V / 50 - 60 Hz:
	High Frequency Regulator, DALI (HFD)		High Frequency Performer (HFP)
			High Frequency Regulator (HFR)
Option	Emergency lighting:
	1 hour (EL1)		High Frequency Basic (HF-Dali)
	3 hours (EL3)
		Option	Emergency lighting:
Material	Sheet steel in white (WH) or silver (SI)		1 hour (EL1), 3 hours (EL3)
Installation	Click-in fixation (mechanical and electrical) on		2-lamp lampholder of 32 mm (F32) to be used in
	trunking		facetted and aluminum reflectors, standard is 115
			mm
			Master/slave unit: pair of electrical units one with
			gear (M) one without gear (S)
		Material	Sheet steel in white (WH) or silver (SI)
		Installation	Click-in fixation (mechanical and electrical) on
			trunking
		Remarks	Dedicated IP40 sets for upgrading from IP20 to
			IP40

Where relevant, for detailed descriptions of Lighting Controls we refer you to chapter 11, and descriptions for e.g. optics/optical covers, lamps data, photometrical diagrams, etc. to the respective sections in chapter 12.

8.20 Light-line systems Philips indoor luminaires