Philips SE255 manual Advanced settings, Press m in idle mode, scroll n to Personal SET and press o

free talk mode. This allows you to charge the handset during calls.

The default setting for auto hang up is ON.

1Press m in idle mode, scroll n to PERSONAL SET and press o.

2Scroll n to AUTO HANG-UPand press o. The current setting

is shown.

3Scroll n to select ON or OFF and press o to confirm.

•A validation tone is emitted and the screen returns to the AUTO HANG-UP menu.

7 Advanced settings

7.1Change PIN

The PIN is used for registration/ unregistration of handsets. The default PIN number is 0000. The maximum length of the PIN is 4 digits. This PIN is also used to protect the settings of your handset. Your handset will prompt you whenever the PIN is required.

Note

The default pin code is preset to 0000. If you change this PIN code, keep the PIN details in a safe place where you have easy access to them. Do not lose the PIN code.

1Press m in idle mode, scroll n to ADVANCED SET and press o, and then press o again to enter

CHANGE PIN.

2Enter the current PIN when

prompted and press o to confirm.

•The PIN entered will be shown as asterisks (*) on the screen.

3Enter the new PIN and press o to confirm PIN change. A validation tone is emitted and SAVED appears for a moment, and then the screen returns to the idle screen.

Tip

If you forget your PIN, you will need to reset your phone to its default settings. See section 7.5 “Reset Unit” for more details.

7.2Register

If you wish to register an additional handset or if you have inadvertently unregistered your phone's handset and want to re-register it, follow the procedure described below. This is the procedure for registering handsets of one of the model described in this manual. Procedures may vary for other types of handsets. In this case, please refer to the manufacturer of the handset. Additional handsets must be registered to the base unit before you can use them. Up to 5 handsets can be registered to one base station.

The PIN is required before you can register or unregister handsets.

Note

By default, the PIN is 0000.

1On the base station, press and hold a for approximately 3 seconds. A

beep is emitted to indicate that the

Advanced settings 29