
• DOME RESET
This feature is used to
• SYSTEM INFORMATION
SYSTEM INFORMATION
CAMERA TYPE | : XXXXXXX |
H/W VERSION | : V2.1 |
ROM VERSION | : V2.11 |
PROTOCOL | : F2E |
BAUDRATE | : 9600BPS |
EXIT (ESC TO EXIT) |
|
A Dome camera’s Setup menu provides essential information about the dome camera when service is required. When you view this screen, you can determine the camera type, ROM version. The information on this screen cannot be modified.
4. Troubleshooting
If problems occur, verify the installation of the camera with the instructions in this manual and with other operating equipment. Isolate the problem to the specific piece of equipment in the system and refer to the equipment manual for further information.
Problem | Possible Solution |
| Verify that power is connected to all pieces of equipment in the system. |
No video | Verify that the power switches are in the ON position. |
| Check the video connections (see Figures 4). |
| Check that the BNC connectors are inserted properly. |
| Check the voltage level of the dome camera. |
Poor video quality | Check that 8 pin cable is connected to the Keyboard. Check 8 pin cable for Keyboard is |
| proprietary. (Cable for video is shielded.) |
| Check termination of Video. |
| Reset the cameras using the Dome configuration menus. |
Dome cameras lose their positions. | Check that the dome cameras are inserted properly in the base. |
| Check the voltage level of the dome camera. |
Camera number does not match the multiplexer number. | Check the camera ID and insert the BNC cable into the proper input of the multiplexer. |
Picture is torn when switching | Check Line Lock setting and adjust phase of L/L (see page 25). |
29