Pioneer DEH-P9100R operation manual Using the high pass filter, Adjusting subwoofer settings

Adjusting subwoofer settings

When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer.

1.Press AUDIO and NEXT and then press SW2 to select the subwoofer setting mode.

2.Press 2 or 3 to select the cut-off fre- quency.

Each press of 2 or 3 selects cut-off fre- quencies in the following order:

50 Ô 63 Ô 80 Ô 100 Ô 125 (Hz)

3.Press 5 or ∞ to adjust the output level of the subwoofer.

Each press of 5 or ∞ increases or decreas- es the level of the subwoofer.

•“+6” – “–24” is displayed as the level is increased or decreased.

Note:

•“SW2” is not displayed when the subwoofer output is off in the subwoofer output mode (SW1). In this case, this mode is inactive.

Using the high pass filter

When the subwoofer is connected and you do not want low sound to play from the front or rear speakers, turn the high pass filter on. Only fre- quencies higher than those in the selected range will be output from the front or rear speakers.

Setting the high pass filter for front speakers

1.Press AUDIO and NEXT and then press HPF F to select the high pass filter mode.

2.Press HPF F to turn the high pass filter on.

“HPF ON” appears in the display.

•Press HPF F again to turn the high pass fil- ter off.

3.Press 2 or 3 to select a high pass filter range.

Each press of 2 or 3 selects frequencies in the following order:

50 Ô 63 Ô 80 Ô 100 Ô 125 (Hz)

Setting the high pass filter for rear speakers

1.Press AUDIO and then press NEXT twice.

2.Press HPF R to select the high pass filter mode.

3.Press HPF R to turn the high pass filter on.

“HPF ON” appears in the display.

•Press HPF R again to turn the high pass filter off.

4.Press 2 or 3 to select a high pass filter range.

Each press of 2 or 3 selects frequencies in the following order:

50 Ô 63 Ô 80 Ô 100 Ô 125 (Hz)

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS

60