Installation without the rubber bush (Fig. 6)
Dashboard
Nut (5 mm)
Drill a 5.5 – 6.0 mm diameter hole.
Screw (5 ⋅ 16 mm)
Nut (5 mm) | Screw |
|
Strap
Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle.
<ENGLISH>
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 9)
Frame
Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame.
(When reattaching the frame, point the side with a groove downwards and attach it.)
Fig. 9
Fig. 6
Removing the Unit (Fig. 7) (Fig. 8)
Frame
Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame.
(When reattaching the frame, point the side with a groove downwards and attach it.)
Fig. 7
Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
2.Fastening the unit to the factory radio mounting bracket. (Fig. 10) (Fig. 11)
Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either binding screws (5 ⋅ 8 mm) or flush surface screws
(5 ⋅ 8 mm), depending on the shape of the screw holes in the bracket.
Fig. 10
Screw
Dashboard or Console
Factory radio mounting bracket
Fig. 8 | Fig. 11 |
