Controls and displays
Putting the batteries in the remote control
1Open the battery compartment cover on the back of the remote control.
02
¥ The / / / are also used to navigate on- screen menu system.
¥You can directly access specific channels using numeric keys.
¥Each press of DVD/VCR, switches the screen between the DVD screen (DVD mode) and the VCR screen (VCR mode).
2Insert two AAA/R03 batteries into the battery compartment following the indications
3 Close the cover.
Using the remote control
Keep in mind the following when using the remote control:
¥Make sure that there are no obstacles between the remote and the remote sensor on the unit.
¥Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit's remote sensor.
¥Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit.
¥Replace the batteries when you notice a fall off in the operating range of the remote.
¥Use within the operating range and angle, as shown.
30
30
15ft
Note
Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:
¥Don't mix new and old batteries together.
¥Don't use different kinds of battery together- although they may look similar, different batteries may have different voltages.
¥Make sure that the plus and minus ends of each battery match the indications in the battery compartment.
¥Remove batteries from equipment that isn't going to be used for a month or more.
¥Do not try to recharge batteries not intended to be recharged; they can overheat ant rupture. (Follow battery manufacturerÕs directions.)
¥When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area.
Remote control basics
¥Press STANDBY/ON to turn the DVD/VCR on or off.
¥Press CH + or CH – to move through the channels one channel at a time.
Power Source
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a standard 120V 60Hz polarized AC outlet.
Note
¥Never connect the AC line cord plug to other than the specified voltage (120V 60Hz). Use the attached power cord only.
¥If the polarized AC cord does not fit into a non- polarized AC outlet, do not attempt to file or cut the blade. It is the userÕs responsibility to have an electrician replace the obsolete outlet.
¥If you cause a static discharge when touching the unit and the unit fails to function, simply unplug the unit from the AC outlet and plug it back in. The unit should return to normal operation.
Wider Hole | AC Outlet |
and Blade |
|
Polarized AC Cord Plug | 15 |
(One blade is wider than the other.) |
En
