Creating a video wall

With built-in matrix display capability, you can create a 4-25 video wall.

Connect signal cables and remote cables as shown below.

English

Video signal

 

 

PC/COMPONENT signal

 

 

 

BNC connector

BNC connector

OUT

 

 

 

PC signal/

 

 

VIDEO signal

IN

 

 

IN

VIDEO signal

Remote IN control

RCA phono plug

 

 

COMPONENT

 

 

signal

 

 

OUT

OUT

Remote

 

 

 

 

control

Remote IN

 

 

control

 

 

OUT

PC signal/

COMPONENT signal

Remote control

Note:

1. The VIDEO1 and PC1 terminals can be used for either INPUT or OUTPUT.

When LOOP OUT is ON, do not connect an OUTPUT signal from another unit, that will place an extraordinary load on the other unit and may damage it.

2.LOOP OUT can not be turned ON while signals are input to the PC1 terminal.

3.LOOP OUT can be turned ON while signals are input to the PC1 terminal if the POWER is switched ON.

Information

To loop signals out to another plasma display, set the LOOP OUT to ON.

To create a video wall, set the VIDEO WALL menu items properly.

To connect monitors, please use a 1~2m (3.3~6.6 feet) BNC cable (any commercially available cable).

If the image quality is poor, do not use the monitor’s out terminal. Use a distribution amplifier (any commercially available distribution amplifier) to connect the split signals to the respective monitor INPUT terminals.

Being used as a video wall function, maximaly 4-screen is rough-standard with lower than 1024768, 60Hz signal.

A distribution amplifier is particularly recommended when using 9-screen and over video wall.

From the second monitor onward, connections require a BNC-RCA conversion cable or connector, a mini D-Sub 15 pin cable-BNC (5) cable or a conversion connector.

Cable Management

Using the cable clamps provided with the plasma display, bundle at the back of the unit the signal and audio cables connected to the display.

Back of the unit

mounting hooks

Installation

To attach

To detach

1.

2.

 

clamp

mounting hook

cables

3

En

Page 8
Image 8
Pioneer PDP-42MVE1 manual Creating a video wall, Cable Management, Video signal PC/COMPONENT signal, Clamp, Mounting hook