Pioneer PDP 433CMX Operations, Selecting an Input Source, Before you begin, make sure you have

Operations

Selecting an Input Source

This section explains the basic operation of this unit. Outlined on the following pages is how to turn the main power on and off, put this unit in the operation or standby mode and how to select connected components.

Before you begin, make sure you have:

•Made connections between this unit and personal computer as described in the section “Installation and Connections” starting on page 10.

•Set up the on-screen menu to input signals from components connected to INPUT1 and INPUT2 as described in the section “Setting Up the System” on page 17.

If no connections are made to these terminals, on-screen setup is not necessary.

2,5

2,5

3 3

4

Main Unit Operating	Remote Control Unit
Panel

1Switch MAIN POWER on the main unit to the on position to turn the main power on.

The STANDBY/ON indicator lights red.

2Press STANDBY/ON to put this unit in the operation mode.

The STANDBY/ON indicator turns green.

3Press INPUT on the remote control unit or the main unit to select the input.

Input changes each time the main unit’s INPUT is pressed as follows.

3 INPUT1

INPUT2 2

•When the menu screen is displayed, changing the signal input will cause the menu screen to turn off.

•If the input computer signal is not supported by the display, the following message will be displayed:

I N P U T 1

CA U T I O N

UN S UP P O RT E D S I G N AL

f H : 7 7 . 1 k H z

f V : 8 5 . 0 H z 1 1 5 2 X 8 6 4

F U L L

I N P U T 1

CA U T I O N

OU T OF R AN G E

f H : 7 5 . 7 k H z

f V : 1 2 0 . 0 H z

– – – –

F U L L

4Use VOLUME +/– on the remote control unit to adjust the volume.

If no audio connections are made to this unit, this step is not necessary.

5When viewing is finished, press STANDBY/ON to put the unit in standby mode.

The STANDBY/ON indicator will blink and then remain lit (red) indicating that the standby mode is engaged. Operation is not possible while the STANDBY/ON indicator is blinking (red).

6Switch MAIN POWER on the main unit to the off position to turn the main power off.

The STANDBY/ON indicator may continue to light for a short while even after the main power is turned off. This is a result of residual electric load impressed on the circuitry, and the light will turn off presently.

CAUTION

Please do not leave the same picture displayed on the screen for a long time. Doing so may cause a phenomenon known as “screen burn” which leaves a ghost, or residual, image of the picture on the screen.

19

English

Operations

En