Pioneer VSX-43TX Bass Peak Level, Use the 5∞ buttons to adjust the, peak level, 4Press ENTER

Fine Tuning Your System

BASS PEAK LEVEL

The LFE (Low Frequency Effect) channel in Dolby Digital and DTS program sources can produce heavily concentrated ultra-low bass tones that may exceed the capabilities of your speaker system. The following steps show you how to set the peak level for the LFE channel. If continuing from the preceding page the BASS PEAK LEVEL should be selected.

MENU		MASTER	TOP MENU		3 Use the 5∞ buttons to adjust the
	TUNER EDIT
		VOLUME			test tones and specify the bass
		TUNE	GUIDE	1-5
SYSTEM					peak level.
SETUP			ST
		ENTER
	ST

AUDIO		RETURN
	TUNE
CHANNEL−	DTV ON/OFF BAND	CHANNEL+

SIGNAL dB

ANALOG

SB CH

ON MOVIE

AUTO OFF MUSIC

SP A B

D.ACCESS MPX CLASS

1-5

If you set this level before the receiver

will have that level input but it will not appear on this setup screen. (The screen will always open with the level showing [- - -].)

STANDBY/ON
		STANDBY
MOVIE	MUSIC	ENTER

MULTI JOG

MULTI JOG	CONTROL	SIGNAL	HI-BIT	SB CH	MIDNIGHT	LOUDNESS	BAND
SET UP	RETURN	SELECT	HI-SAMPLING	MODE
PHONES			TONE CONTROL
	SPEAKERS	TONE	BASS/TREBLE

1Raise the level gradually.

2Set the bass peak level at the point just before

the tone starts to distort.

Be careful! Test tones play back at loud volumes . Make sure there are no infants or small children in the room at distortion level.

You can leave this setup any time by pressing

ENTER.

Follow steps 1-5 on page 79, if necessary, to get to the starting point mentioned here.

1BASSPEAK LEVEL should be selected, if it isn’t use the 5∞ buttons to select it. Press

ENTER.

SIGNAL dB

ANALOG

SB CH

ON MOVIE

AUTO OFF MUSIC

SP A B

2Use the 5∞ buttons to select

SETTING START or SETTING

CANCEL. Press ENTER.

SETTING START: The MASTER VOLUME is set to MIN (----dB), a test tone plays back and you

make the setting (go to step 3).

SIGNAL	dB
ANALOG
SB CH
AUTO ON	MOVIE
OFF	MUSIC
	SP A B

SETTING CANCEL: This setting won't limit the peak level of the LFE channel.

SIGNAL dB

ANALOG

SB CH

ON MOVIE

AUTO OFF MUSIC

If the YES or PLUS setting on the subwoofer is selected the test tone will only play back from the subwoofer. If not, the test tone will play back from all speakers set to LARGE except for the subwoofer.

4Press ENTER.

The display on the receiver will show RESUME and the MASTER VOLUME will return to its original position.

5EXIT should be selected (if it isn’t use the 5∞ buttons to select it)

and press ENTER.

Next, if you want, proceed to DYNAMIC RANGE CONTROL

SP A B

If you selected SETTING CANCEL go to step 4.

86