Additional Information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.
Symptom |
|
| Cause |
| Remedy | |
The power does not | • | The power plug is disconnected. | • | Connect the power plug to the wall | ||
turn ON. |
|
|
|
|
| outlet. |
|
|
| • | The protection circuit may have | • | Disconnect the power plug from the |
|
|
|
| been activated. |
| outlet, and insert again. |
The unit does | not | • | Static electricity caused by dry air. | • | Disconnect the power plug from the | |
respond | when | the |
|
|
| outlet, and insert again. |
buttons are pressed. |
|
|
|
| ||
|
|
|
| |||
No sound is output | • | Improper connections. | • Make sure the component is connected | |||
when a | function is |
|
|
| correctly (refer to pages 8 to 15). | |
selected. |
|
| • | Sound is muted. | • Press MUTING on the remote control. | |
|
|
| • The volume is turned down. | • | Adjust MASTER VOLUME. | |
|
|
| • The MONITOR is ON. | • | Press the MONITOR button. | |
|
|
| • Speakers are turned OFF. | • Press SPEAKERS to select the speakers | ||
|
|
|
|
|
| you connected. |
|
|
|
| |||
No image is output | • | Improper connections. | • Make sure the component is connected | |||
when a | function is |
|
|
| correctly (refer to pages 8 to 15). | |
selected. |
|
| • | The input source is not properly | • Press the correct function button. | |
|
|
|
| selected. |
|
|
|
|
|
|
|
|
|
Considerable noise in radio broadcasts.
• | Incorrect frequency. | • Tune in the correct frequency. | |||
• The antenna is not connected. | • | Connect the antenna (refer to page 13). | |||
• 2RF and/or digital cables are near | • | Route 2RF and digital cables away | |||
| the antenna terminals and wires. |
| from the antenna terminals and wires. | ||
FM broadcasts |
|
|
|
| |
|
| • | Fully extend the FM wire antenna, | ||
• The FM antenna is not fully | |||||
| extended or is poorly positioned. |
| position for best reception, and secure | ||
|
|
|
|
| to a wall. |
• | Weak radio signals. | • Connect an outdoor FM antenna (refer | |||
|
|
|
|
| to page 13). |
AM broadcasts |
|
|
| ||
| • | Adjust the direction and position for | |||
• The AM antenna is poorly | |||||
| positioned. |
| best reception. | ||
• | Weak radio signals. | • Connect an additional internal or external | |||
|
|
|
|
| AM antenna (refer to page 13). |
• Interference cause by other | • | Turn off the equipment causing the | |||
| equipment (fluorescent lamp, |
| noise or move it away from the receiver. | ||
| motor, etc.). | • Place the antenna farther away from the | |||
|
|
|
|
| equipment causing the noise. |
51