09Controlling the rest of your system
Searching for preset codes
Another way of entering preset codes is to use the search feature. The remote transmits batches of 10 codes; when you see the component you want to control respond (by turning on or off), you just scan through the last 10 codes until you find the right one.
SOURCE | RECEIVER | ||||
DVD |
| TV | VCR |
| |
|
| MULTI CONTROL |
|
| |
RCV |
| CD | TUN |
| TVC |
1 |
| 2 |
|
| 3 |
TESTTONE | INPUT ATT | FL DIMMER | |||
4 |
| 5 |
|
| 6 |
CH SELECT |
| LEVEL |
| ||
7 |
| 8 |
|
| 9 |
+10 |
|
| EFFECT | DISPLAY | |
|
| 0 |
|
| DISC |
|
|
| ENTER | ||
DTV INFO | MPX/RETURN | D.ACCESS | T.EDIT/GUIDE | ||
¶ |
| 7 | 3 |
| 8 |
BAND |
| CLASS | DTV ON/OFF | DTV MENU | |
1 |
| ¡ | 4 |
| ¢ |
TOP MENU |
| AUDIO | SUBTITLE | ANGLE | |
REMOTE SETUP | STANDARD | ADV.SURR. | STEREO | ||
INPUT SEL. | SIGNAL SEL | MIDNIGHT/ | MUTE | ||
LOUDNESS | |||||
|
| RECEIVER CONTROL |
| ||
|
| TUNE |
|
|
|
ST |
| SETUP |
| ST | |
|
|
|
| ||
ENTER
TUNE 
CHANNEL
1Switch on the component you want to control.
If the component is some kind of player (CD player, VCR, etc.), start it playing.
2Press and hold REMOTE SETUP for three seconds.
The LED lights steadily for two seconds.
3Press the MULTI CONTROL button for the component you want to control.
4Press and hold REMOTE SETUP for three seconds.
A batch of 10 codes is transmitted and the LED blinks during transmission. If the component responds, by stopping or switching off, go to the
next step, otherwise repeat this step.
5Switch the component back on or restart playback.
6Use ’ and ‘ to scan through the last
10codes transmitted to identify the correct code.
Stop when you see the component stop or switch off. The LCD display on the remote shows the I.D.
You can also verify you have the correct code by adjusting the volume, pressing 3, 7, etc.
7Press and hold ENTER for three seconds to save the preset code.
Programming signals from other remote controls
(VSX-D811S only)
If the preset code for your component is not available, or the available preset codes do not operate correctly, you can program signals from the remote control of another component. This can also be used to program additional operations (buttons not covered in the presets) after assigning a preset code.
1Press REMOTE SETUP and hold for three seconds.
The LED lights steadily for two seconds.
2Press the MULTI CONTROL button for the component you want to control.
3Prepare the remote to learn the remote control signal from the component.
Press and hold the RECEIVER 
button for two seconds.
The LED lights steadily to indicate the remote is ready accept a signal.
To exit or cancel press and hold the REMOTE SETUP key for three seconds.
50
En
XRB3013A.49.67 | 50 | 01.12.12, 4:48 PM |
