Pioneer VSX-D711 Setting the remote to control other components, Selecting preset codes directly

Controlling the rest of your system

Setting the remote to control other components

There are several ways to set your remote to control the other components in your system. The easiest way to do this is to assign the component’s manufacturer preset code (listed on pages 56–67) to one of the MULTI CONTROL buttons on the remote control.

The buttons can be set to control the following components:

Button	Controllable Components
DVD:	DVD or LD player
TV:	TV or Satellite tuner
VCR:	VCR or Digital Video Recorder
CD:	CD player
CD-R:	CD Recorder, Tape deck
	or MD player
TVC:	TV or Cable TV tuner
TUN:	FM/AM tuner

You can do this directly, or by searching through different preset codes until you find the right one. If you can’t find a preset code that matches the component you want to control, you can still teach the remote individual commands from another remote control (page 50).

You can cancel or exit any of the steps by pressing and holding MUTE for three seconds.

XRB3013A.49.67 49

09

Selecting preset codes directly

SOURCE			RECEIVER
DVD		TV	VCR		CD-R
		MULTI CONTROL
RCV		CD	TUN		TVC
1		2			3
TEST TONE		INPUT ATT		FL DIMMER
4		5			6
CH SELECT			LEVEL
7		8			9
+10			EFFECT		DISPLAY
		0			DISC
				ENTER
DTV INFO	MPX/RETURN		D.ACCESS		T.EDIT/GUIDE
¶		7	3		8
BAND		CLASS	DTV ON/OFF		DTV MENU
1		¡	4		¢
TOP MENU		AUDIO	SUB TITLE		ANGLE
REMOTE SETUP	STANDARD		ADV.SURR.		STEREO
INPUT SEL.	SIGNAL SEL		MIDNIGHT/		MUTE
			LOUDNESS
		RECEIVER CONTROL
		TUNE
ST		SETUP			ST

ENTER

TUNE

CHANNEL

1Press and hold REMOTE SETUP for three seconds.

The LED lights steadily for two seconds.

2Press the MULTI CONTROL button for the component you want to control.

3Use the number buttons to enter the 4 digit preset code (see pages 56–67)

The LED blinks for half a second after you input each digit and shows a long, two second blink once you have entered a valid code. If the LED blinks three times it means an invalid code has been input or an error has occurred.

•If you assign a preset code for the TUNER button, you won’t be able to control the built-in tuner of this receiver using the remote. Reset the remote to the built-in tuner by entering the preset code 7008.

4Repeat steps 1 through 3 for the other components you want to control.

49

En

01.12.12, 4:48 PM