Pioneer VSX-D711, VSX-D811S manual Additional information, Front panel refer to, Light

Additional information 10

Problem Remedy

No sound from surround or center speakers.

•Refer to Speaker setting on page 39 to check the speaker settings.

•Refer to Setting the relative volume level of each channel on page 44 to check the speaker levels.

•Connect the speakers properly (refer to page 19–21).

No sound from surround back speakers.

•Refer to Surround back speaker setting on page 40 to check the surround back speaker settings.

•Refer to the table on page 33 to make sure the 6.1 channel setting and the sound mode are set for surround back sound.

Noise during playback of a cassette deck.

•Move the cassette deck further from your receiver, until the noise disappears.

Sound is produced from other components, but not from LD or DVD player.

•Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG according to the type of connections made. (refer to page 34).

•Set the digital input settings correctly (refer to page 43).

•Make digital connections (refer to page 14) and set the SIGNAL SELECT to DIGITAL (refer to page 34).

•Refer to the instruction manual supplied with the DVD player.

No sound is output or a noise is output when software with DTS is played back.

•Set the digital volume level of the player to full, or to the neutral position.

When a search is performed by a DTS compatible CD player during playback, noise is output.

•This is not a malfunction, but be sure to turn the volume down to prevent the output of loud noise from your speakers.

Can’t operate the remote	• Replace the batteries (refer to page 6).
control.	• Operate within 23 feet ( 7 m), 30° of the remote sensor on the
	front panel (refer to page 6).
	• Remove the obstacle or operate from another position.
	• Avoid exposing the remote sensor on the front panel to direct
	light.
The display is dark or off.	• Press FL DIMMER on the remote control repeatedly to return
	to the default.

If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.

69

En

XRB3013A.68.74 69 01.12.12, 5:13 PM