Pioneer VSX-D711 Erasing one of the remote control button settings, Repeat to erase other buttons

Controlling the rest of your system

4Point the two remote controls towards each other about 1-2 inches apart then press the button that will be doing the learning on this receiver’s remote control (for example 3, 7, etc.).

The LED flashes rapidly.

1 - 2 inches	3	6	9	8	¢
				3	4
	2	5	8	0
				7	¡
	1	4	7		1
				¶

5Press the corresponding button on the other remote control that is sending (teaching) the signal to this receiver’s remote control (for example 3, 7, etc.).

If the operation has been learned successfully, the LED on this receiver’s remote will go out and then light steadily.

If for some reason the operation hasn’t been learned the LED will blink for three seconds and then light steadily. If this happens, keep pressing the (teaching) button as you vary the distance between the two remotes, until you see the the LED light steadily.

To program additional operations for the current component repeat steps 4 and 5.

To program operations for another component exit and repeat steps 1 through 5.

6Press and hold the REMOTE SETUP button for three seconds to store the operation(s).

•Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer together or farther apart.

•Certain buttons represent operations that cannot be learned from other remote

controls. These include: RECEIVER , REMOTE SETUP and the MULTI

CONTROL, RECEIVER CONTROL and MASTER VOLUME buttons.

09

•TV CONTROL buttons (TV , TV VOL +/-, and TV INPUT) can only be learned after selecting TV or TVC.

Erasing one of the remote control button settings

(VSX-D811S only)

This erases one of the buttons you have programmed and restores the button to the factory default.

1Press REMOTE SETUP and hold for three seconds.

The LED lights steadily for two seconds.

2Press the MULTI CONTROL button relating to the button setting to be erased.

3Prepare the remote to erase the button setting.

Press the RECEIVER button twice quickly.

The LED blinks to indicate the remote is ready to erase the button setting.

4Press and hold the button to be erased for three seconds.

The LED lights steadily for three seconds and then goes off.

5Repeat step 4 to erase other buttons.

6Press and hold the REMOTE SETUP button for two seconds to exit.

Clearing all the remote control settings

You can clear all presets and restore the factory default settings.

1Press REMOTE SETUP and hold for three seconds.

The LED lights steadily for two seconds.

51

En

XRB3013A.49.67 51 01.12.12, 4:49 PM